Page 27
Source waveform measurement: automatic
measurement software (N5399A)
D2
D1
D0
CLK
3.3V bias
DDC/CEC/HP
D/+5V
To DUT
The case of probe and fixture connection used
when performing differential signal measurement
N5399A HDMI Scope Tool
Measurement item selection display case
•By using probe 4ch to perform automatic and
continuous measurement, it can provide
effective measurement results
•It only needs less than 20 minutes for one
measurement rate (it needs about 8 minutes
for differential signal measurement and about
10 minutes for single-ended measurement)
•It can perform automatic and continuous
measurement on each measurement item of
differential signal without needing to change
and reconnect probe and fixture
HTML format of measurement report
Page 28
Change in CTS 1.3b source test
• The measurement data rate is increased to 3.4Gb/s (The measurement can be performed at
maximum rate supported by the device)
• The bandwidth required for oscilloscope: 8GHz
• Judgment standard changes as the specification changes
• Change in TP1 eye mask shape, mitigation in VL judgment conditions
• Add communication protocol test of HDMI 1.3 extension capabilities
• Communication protocol test like Deep Color, xvYCC, High Bitrate Audio and one bit
Audio.
DSO80000B Series Oscilloscope N5998A Protocol Analyzer Generator
Comments to this Manuals