Quantum Data 801GF Operations Instructions Page 2

  • Download
  • Add to my manuals
  • Print
  • Page
    / 10
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 1
Notes
= jumper in = jumper out
ISA 7
ISA 6
ISA 5
ISA 4
ISA 3
ISA 2
ISA 1
ISA 0
0 1 2
268
260
258
250
318
310
308
300
ISA
Base I/O
(Hex)
Installation
Before you install the Quantum Data 801GC-ISA or 801GF-ISA card
Determine which port is available for use
Determine the correct ISA or base I/O address
Make sure the contents of the kit are near your computer so you can follow the steps in order
without stopping.
1. Make sure your computer and monitor are turned off.
This protects the card from possible electrical damage when you connect your system
components later.
Important — For now, leave the line cord for the computer plugged in.
2. Remove the cover from the computer.
See the manual that came with your computer for
specific instructions.
3. Touch the metal part of the power supply case
inside the computer to discharge any static
electricity that you might have.
See the manual that came with your computer to locate
its power supply.
4. Unplug the computers line cord.
5. Locate a full-size, unobstructed slot on your
computer.
See the manual that came with your computer.
6. Remove the backplate for this slot.
7. Remove the 801GC-ISA or 801GF-ISA card from its static-proof bag.
Hold the card by its edges to avoid touching the connector on the card.
8. Prepare the card for your correct ISA or base I/O address.
This is done by placing the provided jumpers in the pattern for your ISA or
I/O shown in this table. The card comes with a default setting of ISA 0
(base I/O 300H).
There are two other jumper positions:
X and M. Position X is empty and M
always has a jumper.
Jumper
Locations
GFGC
Power supply
Model 801GC-ISA & 801GF-ISA Quick Start Guide • 19
• 2 Model 801GC-ISA & 801GF-ISA Quick Start Guide
Page view 1
1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments